header

Observed Mitigation of Local Amorphization in Boron-Rich Boron Carbide

30 Pages Posted: 3 Jul 2019 Publication Status: Accepted

See all articles by Ankur Chauhan

Ankur Chauhan

Department of Mechanical Engineering, The Johns Hopkins University

Mark C. Schaefer

Rutgers, The State University of New Jersey - Department of Materials Science and Engineering

Richard A. Haber

Rutgers, The State University of New Jersey - Department of Materials Science and Engineering

Kevin J. Hemker

Johns Hopkins University - Department of Mechanical Engineering; Hopkins Extreme Materials Institute

Abstract

Boron carbide is extremely hard but has been shown to undergo stress-induced amorphization when subjected to large nonhydrostatic stresses. This localized amorphization has been associated with the sudden loss of shear strength and poor ballistic performance. Recent quantum mechanics predictions suggest that boron-enrichment may be used to mitigate amorphization in boron carbide. As a means to test this hypothesis, stoichiometric boron carbide (nominally B4C) and a novel composition of B-rich boron carbide (nominally B6.3C) were investigated. Nanoindentation followed by Raman spectroscopy revealed an obvious reduction in the Raman peaks associated with amorphization in the B-rich material. Transmission electron microscopy observations of the region below the nanoindents facilitated direct observation of amorphization, confirmed the Raman result that amorphization is reduced in the B-rich specimens, and provided additional insight into deformation mechanisms. It is concluded that boron-rich alloys offer one path to mitigating local amorphization in boron carbide.

Keywords: Boron Carbide, Amorphization, Nanoindentation, TEM, Raman Spectroscopy

Suggested Citation

Chauhan, Ankur and Schaefer, Mark C. and Haber, Richard A. and Hemker, Kevin J., Observed Mitigation of Local Amorphization in Boron-Rich Boron Carbide (July 3, 2019). Available at SSRN: https://ssrn.com/abstract=3414007 or http://dx.doi.org/10.2139/ssrn.3414007

Ankur Chauhan (Contact Author)

Department of Mechanical Engineering, The Johns Hopkins University

3400 N. Charles Street St. 313 Ames Hall
Baltimore, MD 21218
United States

Mark C. Schaefer

Rutgers, The State University of New Jersey - Department of Materials Science and Engineering

United States

Richard A. Haber

Rutgers, The State University of New Jersey - Department of Materials Science and Engineering

United States

Kevin J. Hemker

Johns Hopkins University - Department of Mechanical Engineering ( email )

3400 N. Charles Street St. 313 Ames Hall
Baltimore, MD 21218
United States

Hopkins Extreme Materials Institute ( email )

United States

Do you have negative results from your research you’d like to share?

Paper statistics

Downloads
131
Abstract Views
697
PlumX Metrics